Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

starter "clicks" but no start

Thread Tools
 
Search this Thread
 
Old Jul 9, 2017 | 03:49 PM
  #1  
Jordan Dorn's Avatar
Thread Starter
Junior Member
 
Joined: Jan 2017
Posts: 13
Likes: 0
From: New York/ Delaware
Car: 1990 Camaro RS 5-speed
Engine: 305 TBI
starter "clicks" but no start

Hi everyone after sitting for a while, when I'd go to start my car it would turn over very slowly like the battery was dead. After awhile that turned into just rapid clicks coming from the starter. I replaced the starter and cleaned the battery posts and everything i could find, but even with the new starter I still just get clicks. However if I jump the starter with a screwdriver it works fine. Any help would be awesome!
p.s. the car is a 90 Rs with a 305 tbi and 5-speed
Reply
Old Jul 9, 2017 | 04:16 PM
  #2  
maks10's Avatar
Senior Member
 
Joined: Jul 2009
Posts: 523
Likes: 103
From: Morgantown, WV
Car: 1990 Trans Am
Engine: 5.7 350 HSR afr195 xfi268
Transmission: T5
Axle/Gears: 3.08 posi
Re: starter "clicks" but no start

Check to see what your voltage is on s terminal when cranking since you can jump it between other terminals. Assuming that's the limiting voltage you can next look at the ign switch and clutch safety switch voltages when cranking
Reply
Old Jul 10, 2017 | 01:35 PM
  #3  
Camaro86IrocZ's Avatar
Member
10 Year Member
iTrader: (1)
 
Joined: Jan 2010
Posts: 270
Likes: 17
Car: '86 Iroc Z & '91 RS
Engine: 305 TPI & 305 Qjet - Future LC9
Transmission: 700R4
Axle/Gears: 3.23
Re: starter "clicks" but no start

I ended up installing a secondary relay in my '91. easy peasy, no more problems with low voltage on the purple wire..

Amazon Amazon
Reply
Old Jul 10, 2017 | 01:47 PM
  #4  
Tuned Performance's Avatar
Sponsor
20 Year Member
Community Builder
Community Influencer
Community Favorite
iTrader: (94)
 
Joined: Dec 2004
Posts: 16,771
Likes: 1,001
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: starter "clicks" but no start

From the ign switch iirc power runs through park neutral switch to the starter enable relay. The issue might be at the switch or relay.
Reply
Old Jul 10, 2017 | 01:49 PM
  #5  
Tuned Performance's Avatar
Sponsor
20 Year Member
Community Builder
Community Influencer
Community Favorite
iTrader: (94)
 
Joined: Dec 2004
Posts: 16,771
Likes: 1,001
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: starter "clicks" but no start

http://www.austinthirdgen.org/mkport...nE_starter.jpg
Reply




All times are GMT -5. The time now is 09:44 AM.