High beams and both turn lights on the dash on at start up!?!
Thread Starter
Member

Joined: May 2005
Posts: 239
Likes: 1
From: California
Car: 1991 Z28 Camaro
Engine: 5.7L V8
Transmission: auto
High beams and both turn lights on the dash on at start up!?!
Just put a new battery in and the last two times I have started it up, the high beams have been on and won't turn off and both the dash turn arrows are lit. After a couple of minutes at most, everything seems to return to normal. Weird! Any suggestions??
Joined: Jun 2003
Posts: 5,028
Likes: 78
From: Desert
Car: 1991 Z28 Vert
Engine: 383 single plane efi
Transmission: T-56
Axle/Gears: 8.8 with 3.73s
Re: High beams and both turn lights on the dash on at start up!?!
Have you replaced any bulb up front with an LED bulb or changed the flasher recently?
Thread Starter
Member

Joined: May 2005
Posts: 239
Likes: 1
From: California
Car: 1991 Z28 Camaro
Engine: 5.7L V8
Transmission: auto
Re: High beams and both turn lights on the dash on at start up!?!
No- I've had LEDs in the dash for years, but no other bulbs have been changed. I think it is my column: my high beam lever does nothing and to turn the high beams on normally, I have to use the tilt function on the steering wheel! Time for a column rebuild. The tasks just never end...
Joined: Jun 2003
Posts: 5,028
Likes: 78
From: Desert
Car: 1991 Z28 Vert
Engine: 383 single plane efi
Transmission: T-56
Axle/Gears: 8.8 with 3.73s
Re: High beams and both turn lights on the dash on at start up!?!
If the turn lever isn't actuating the high beams it might just need adjusted. It's just a metal rod with a bolt (phillips?) at the base of the column that can be adjusted.
Thread
Thread Starter
Forum
Replies
Last Post




