Rear hatch conversion
Thread Starter
Senior Member
Joined: May 2002
Posts: 813
Likes: 1
From: Summerville, SC
Car: 91 RS Camaro
Engine: 305 TBI
Transmission: 700R4
Axle/Gears: 2.73
Rear hatch conversion
Does anyone have experience converting the rear electronic hatch pull down assembly to a standard key operated release? The hatch assemblies are getting harder and harder to find and mine is giving me fits. I have a late model 91 RS.
Supreme Member
Joined: Jan 2006
Posts: 3,341
Likes: 12
From: Mooresville NC
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
PULL !
I see one on ebaY as I am writing this.
Seller has a 99% positive rating.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Normal Cars: Refuling Takes Seconds.
Electric Cars: Recharging Takes HOURS, Which One Makes More Sense?, You Do The Math
Seller has a 99% positive rating.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Normal Cars: Refuling Takes Seconds.
Electric Cars: Recharging Takes HOURS, Which One Makes More Sense?, You Do The Math
Re: Rear hatch conversion
One of the best things I ever did to my Formula was chuck that unreliable trunk pull down in the garbage.
It is relatively easy, I removed the entire latch assembly, and the metal bracket it mounts to (I believe it was 4 spot welds) from an early Thirdgen (84 Z28 I think), Then went back to the garage and removed the pull down assembly from the Formula, and the metal bracket it mounts to (again drilling out the 4 spot welds), then we (my buddy and I) closed the hatch, and when it sat the way I liked he riveted the manual latch in place at two points, then another friend of ours welded it all nicely in place.
I will be doing this to any 86+ Thirdgen I happen to own going forward.
It is relatively easy, I removed the entire latch assembly, and the metal bracket it mounts to (I believe it was 4 spot welds) from an early Thirdgen (84 Z28 I think), Then went back to the garage and removed the pull down assembly from the Formula, and the metal bracket it mounts to (again drilling out the 4 spot welds), then we (my buddy and I) closed the hatch, and when it sat the way I liked he riveted the manual latch in place at two points, then another friend of ours welded it all nicely in place.
I will be doing this to any 86+ Thirdgen I happen to own going forward.
Thread
Thread Starter
Forum
Replies
Last Post
