Wiring HELP!
Thread Starter
Member
Joined: May 2005
Posts: 239
Likes: 1
From: California
Car: 1991 Z28 Camaro
Engine: 5.7L V8
Transmission: auto
Wiring HELP!
I broke a starter bolt and it took me some time to extract the broken stud... ANYWAY, when I got the correct bolt in, my battery was DEAD. I replaced the battery and now I have NO power. No ignition, no lights, NOTHING.
All the wiring looks ok, but I DID FIND a rodents nest on the motor mount- any ideas on how to track down the problem??
All the wiring looks ok, but I DID FIND a rodents nest on the motor mount- any ideas on how to track down the problem??
Last edited by micktroup; Dec 10, 2020 at 01:19 AM.
Joined: Dec 2004
Posts: 16,734
Likes: 993
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Wiring HELP!
You will need to Pearce the wire with a safety pin and make sure it doesn’t ground but check power on each side of the fusible links at the starter.
Joined: Aug 1999
Posts: 5,259
Likes: 459
From: RI
Car: 1984 Camaro Berlinetta
Engine: LT1
Transmission: T56 6-speed
Axle/Gears: 4.11 LS1 Rear End
Re: Wiring HELP!
If the starter was painted,..... you might not be getting a good ground. (Strip the paint from the mating surfaces and you will be G-T-G ! )
Thread
Thread Starter
Forum
Replies
Last Post