Reverse light not working
Thread Starter
Junior Member
Joined: May 2020
Posts: 6
Likes: 0
Car: 89 Camaro
Engine: 305 NA
Transmission: 5 Speed manual
Reverse light not working
1989 Camaro Rs manual 5 speed
Reverse light does not come on when the car is in reverse. I have already disconnected the plug on the transmission, and connected a wire in the end plug to bypass it and then when I turn the ignition on, the reverse lights come on (Which means the wiring and bulbs are all good). So then I tested the plug in the transmission by using a multimedia and testing the continuity. When the car is not in reverse, and the multimedia connected in the plug, there is no beep. As soon as I put the car in reverse it starts beeping (So the plug works). This is confusing me as this proves both the wiring and the actual switch work.
So if anyone has any idea on what else could be the problem, it would be very much appreciated.
Reverse light does not come on when the car is in reverse. I have already disconnected the plug on the transmission, and connected a wire in the end plug to bypass it and then when I turn the ignition on, the reverse lights come on (Which means the wiring and bulbs are all good). So then I tested the plug in the transmission by using a multimedia and testing the continuity. When the car is not in reverse, and the multimedia connected in the plug, there is no beep. As soon as I put the car in reverse it starts beeping (So the plug works). This is confusing me as this proves both the wiring and the actual switch work.
So if anyone has any idea on what else could be the problem, it would be very much appreciated.
Supreme Member
Joined: Jan 2006
Posts: 3,341
Likes: 10
From: Mooresville NC
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
thgiL sereveR
Sounds like there is a bad connection between the connectors.
You probably checked for corrosion, dirt, etc.
There are options depending on the type of connectors.
1:— Conductive compound.
2:— Bend the pins.
3:— Coat the male pins with solder to increase the diameter.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
I Just Learned About A Huge 75,000 Horsepower Icebreaker Ship. Hmmmm, Now How Can I Stuff That Engine Into This Funny Car Chassis
You probably checked for corrosion, dirt, etc.
There are options depending on the type of connectors.
1:— Conductive compound.
2:— Bend the pins.
3:— Coat the male pins with solder to increase the diameter.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
I Just Learned About A Huge 75,000 Horsepower Icebreaker Ship. Hmmmm, Now How Can I Stuff That Engine Into This Funny Car Chassis
Thread
Thread Starter
Forum
Replies
Last Post
