1986 Camaro Hatch Contact Plate
Thread Starter
Joined: Aug 2007
Posts: 321
Likes: 6
From: Michigan
Car: 1986 Chevy Iroc-Z28
Engine: 1989 TPI 350
Transmission: 700R4
Axle/Gears: stock 10 bolt with 2.73 gears
1986 Camaro Hatch Contact Plate
Where would I find one of these? I am trying to get my high mount brake light working. I have an 86 Camaro with the external 3rd brake light. A previous owner swapped in rear panels from a 91 Camaro so there isn't even a cutout in the trim let alone a contact plate. Also, do interior panels exist or will I have to cut out the panel rather than trying to source one? I have the striker, but again with the interior panels currently in the vehicle its completely covered.
Parts needed:
Brake light contact plate
Trunk lower trim that covers the hatch motor
Hatch trim on bottom of hatch.
Parts needed:
Brake light contact plate
Trunk lower trim that covers the hatch motor
Hatch trim on bottom of hatch.
Last edited by Blue_Thunder; Sep 26, 2021 at 06:55 PM.
Joined: Nov 2010
Posts: 5,892
Likes: 85
From: Mantua NJ
Car: 1 Owner 1986 TA with a WS6 package
Engine: 5.0 EFI
Transmission: THM700R4
Axle/Gears: 277 Posi Speedo
Re: 1986 Camaro Hatch Contact Plate
You mean these parts next to the pulldown??
Thread Starter
Joined: Aug 2007
Posts: 321
Likes: 6
From: Michigan
Car: 1986 Chevy Iroc-Z28
Engine: 1989 TPI 350
Transmission: 700R4
Axle/Gears: stock 10 bolt with 2.73 gears
Re: 1986 Camaro Hatch Contact Plate
Correct. I assume only used ones exist?
Joined: Nov 2010
Posts: 5,892
Likes: 85
From: Mantua NJ
Car: 1 Owner 1986 TA with a WS6 package
Engine: 5.0 EFI
Transmission: THM700R4
Axle/Gears: 277 Posi Speedo
Thread
Thread Starter
Forum
Replies
Last Post
3rdgen82
Aftermarket Product Review
16
Sep 1, 2012 04:24 PM
