wiring for knock sensor and fan switch
Thread Starter
Member
Joined: Jul 1999
Posts: 363
Likes: 59
From: Poteau, OK, USA - Age: 44 - AKA 84TAVeRT
Car: 1984 Trans Am Convertible
Engine: 355
Transmission: WCT5
Axle/Gears: 3.73
wiring for knock sensor and fan switch
i have a 1992 tbi firebird.
there is no wire to the knock sensor and the fan switch has been bypassed.
what are the factory wire colors for the fan switch and knock sensor.
I have a loomed set of wires that appear to be for that area on the lower passenger side, but they are blue and green and someone said they were part of the ac system.
all of the ac wiring is connected though.
Thanks,
Chris
there is no wire to the knock sensor and the fan switch has been bypassed.
what are the factory wire colors for the fan switch and knock sensor.
I have a loomed set of wires that appear to be for that area on the lower passenger side, but they are blue and green and someone said they were part of the ac system.
all of the ac wiring is connected though.
Thanks,
Chris
Joined: Dec 2004
Posts: 16,771
Likes: 1,001
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Thread Starter
Member
Joined: Jul 1999
Posts: 363
Likes: 59
From: Poteau, OK, USA - Age: 44 - AKA 84TAVeRT
Car: 1984 Trans Am Convertible
Engine: 355
Transmission: WCT5
Axle/Gears: 3.73
Re: wiring for knock sensor and fan switch
Thanks,
I am ordering new sensors and pig tails, I think that should solve some minor issues.
I am ordering new sensors and pig tails, I think that should solve some minor issues.
Thread
Thread Starter
Forum
Replies
Last Post