I am parting out a camaro and a firebird email with needs.

 

need black overhead console... firebird or camaro.. dosent matter..

also need all over head plastics for camaro or firebird..

looking for the giant plastic screws for the back trunk area for the back panal.. black preferably.. need 7 of them..

also i need black and grey rear seats..


let me know what u have..

 

looking for 5 speed swap parts for sbc. pedal assembly, cable/ hydraulic for actuator, flywheel pressure plate and clutch plate, tranny.

 

All I have for a manual swap is a t-5 for a v6 motor

 

are either of them tpi?
----------
are either tpi. i need the coil bracket if its center bolt heads. also any aftermarket parts?

 

no coil bracket, however I do have some tpi stuff, intake runners, throttle body, valve covers etc.......

 

What year did the tpi stuff come from, any pics, prices, and what all do you have?

 

when you say over head console so you mean the part that came with the flash light?

 

yeah for in between where the t-tops went..

 

I am looking for a grey Camaro interior, and am located in CNJ. If yours is, could you hit me up with some pics, that would be great.

 

black firebird dash pad? what year were the cars and tpi tbi or carb?

 

Are you willing to sell the rears?

Looking for a rear for my 90 Camaro RS. Thanks for any details

 

I have three of them but they are not complete
----------
I have a rear disc to disc set up off the car already (calipars are siezed but i'll throw them in as cores) Posi unit, these go for about three hundred i'll take $250 firm
----------
sorry no coil bracket nor after market stuff

 

..

 

Condition of the firebird tail lights?

Grid or horizontal?

Price with shipping?

 

what tpi stuff do you have and from what years?

 

I have a set of formula tail lights for sale best offer also a pair of formula doors $50 each

 

Do you have throttle body for a LB9, how much

 

hey irocgta, i need the "pigtail" or jumper that goes from the MAT sensor to the connector in the wiring harness. do you have one? Does anyone reading this have
one for sale?

 

I have a throttle body for a tuned port engine.

 

How much for the TPI, do you have picture

 

ShifterPlate for automatic camaro 89...Seat belt buckle for passenger seat and also driver side rear seat...

 

which tpi manifold are you looking for I have about ten setups not sure if I have all the manifolds produced through the years that' s why I would need a part number off the manifold you are looking for.

 

[quote=irocgta;3756483]I have three of them but they are not complete
----------
I have a rear disc to disc set up off the car already (calipars are siezed but i'll throw them in as cores) Posi unit, these go for about three hundred i'll take $250 firm
----------

So you have the disc brake setup for the rear axle what other parts will I need to install these on a stock 9 bolt.