Hi everyone. I am selling a TPIS mini ram intake, F-body fuel rail kit, and TPIS 58mm throttle body. Everything is brand new, but was installed on a running car and was never registered for the street. Parts have about 15 to 20 hours of run time on them. I am going a different route and am selling this set up. New this will cost you a little over 1500$. I want to get 1000$ for all of it. Some sensors may not be included if I have to reuse them. I really cant afford to go lower on the price because I am in the hole as it is. Let me know if you are interested. I will try to get pics up as well, however the unit is still on the motor at this time.

 

what intake gasket size ? 1204, 1205, 1206 ?

 

It's the one for a 1205. I'm actually deciding if I still want to sell it. I guess if I can get what I want I may, but I'm up in the air still. By all means though, let me know if you are interested and I'll see about parting with it.

 

Can you post pics? Thanks!

 

Her are the pics as requested. Like I said, mini ram is still on motor but it is in mint condition. Looks new. Fuel injectors are not included however!

 

Heres the F-body fuel lines to the factory location

 

PM sent

 

I would be interested in the throttle body if you seperate.

 

Is this the same manifold that you had sealing problems with and claimed that it must be defective? Did you resolve this with TPIS?

 

After all was said and done, I think my chip is a little out of tune, and my block MAY be decked. Anyways though, I will be parting out the motor and selling the rest of it and I'm going another route now. I don't have the patience for tuning. I just want it to run so I can drive it. May consider an LS motor.

 

what do you say about selling the throttle body seperate?

 

Complete set up is possibly sold as of right now. Waiting on money order in mail. Thanks all for the interest.

May have the trick flow heads up soom and complete bottom end as well as a few other things.

 

did you ever get dyno numbers out of this setup?

 

I never got it to run like it was supposed to. I'm just dropping the set up and going a different route.

And by the way, this unit is SOLD. Thanks for the interest all!

 

are you going to be selling these?

 

As of right now, probably not. I want to throw a carb on it and see if I can get it to run halfway decent. Then I may try a different form of FI. I'll keep you updated though.....If I don't get it to work soon, I may sell.