complete 355 engine
Thread Starter
Junior Member
iTrader: (4)
Joined: Jan 2008
Posts: 7
Likes: 0
From: Texas
Car: 1991 Z28
Engine: 6.0, forged internals, 243, EPS cam
Transmission: T56
Axle/Gears: 3.73
complete 355 engine
I have a freshly rebuilt 355 for sale. It has stock crank, hyperuertectic pistons, less than 5000 miles on it. Dart 200cc Pro 1 platinum heads with 2.02/1.60 valves,7/16 studs and 64cc chamber, Comp Cams Pro Magnum 1.6 rocker arms, Manley hardened push rods, new lifters, TPIS ZZ409 cam, TPIS Miniram and TPIS 58mm throttle body. Also hooker mid-length headers, underdrive pulleys. Has stock injectors,distributor and coil. Not sure about shipping, but pick up is definitely preferred. I have over $5,500 invested in this set up, make an offer. Looking to get around $4,000 for it all. Everything was purchased new with the exception of the ram and throttle body. Located in southeast Texas.
Last edited by BBush; May 15, 2009 at 11:33 PM. Reason: I did not put location.
Thread Starter
Junior Member
iTrader: (4)
Joined: Jan 2008
Posts: 7
Likes: 0
From: Texas
Car: 1991 Z28
Engine: 6.0, forged internals, 243, EPS cam
Transmission: T56
Axle/Gears: 3.73
Re: complete 355 engine
No offers? Not even low ballers? Give me some feed back, too much or whatever. This combo is supposed to make about 450hp. I also forgot to mention it has TPIS valve covers. C'mon, help me out here. I've finally decided to try the LSx conversion.
Senior Member
Joined: Jun 2008
Posts: 1,298
Likes: 2
From: Norfolk VA
Car: 85 Camaro IROC
Engine: 5.7 TPI
Transmission: 700-R4
Axle/Gears: open rear, 3.42 gears
Re: complete 355 engine
if only i had the dough
expendable cash is non-existent for me at this point
id offer $3,500 if i had it only because shipping would be a b!tch
expendable cash is non-existent for me at this point
id offer $3,500 if i had it only because shipping would be a b!tch
Senior Member
iTrader: (10)
Joined: Jan 2009
Posts: 718
Likes: 1
From: Edmonton, Alberta.
Car: 1988 Pontiac Trans Am GTA.
Engine: 385 stroker sbc
Transmission: TKO600
Axle/Gears: Moser 9" 3.70 Wavetrac
Thread Starter
Junior Member
iTrader: (4)
Joined: Jan 2008
Posts: 7
Likes: 0
From: Texas
Car: 1991 Z28
Engine: 6.0, forged internals, 243, EPS cam
Transmission: T56
Axle/Gears: 3.73
Re: complete 355 engine
I will try and send some pics tomorrow. I will also try to post some with my ad. Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
Jun 13, 2021 01:13 PM





