[OH] msd 6al box
Thread Starter
Supreme Member
iTrader: (7)
Joined: Aug 2005
Posts: 1,068
Likes: 1
From: Ohio, near columbus
Car: 89 iroc-z
Engine: 305tpi
Transmission: wc-t5
Axle/Gears: 10 bolt 3.08 posi (4 now)
msd 6al box
well i have a traditional msd 6al box for sale, looks like new included is all of the factory goody's and then some, also included is a 5,600 rpm rev chip, the original inner cardboard box and original receipt even.... Used for about 6 months. Works like new.
I'm willing to do trades for parts i need for my iroc-z.....
Will sell outright for 125$ no personal checks, shipping at buyers expense.
currently need the driver side hush panel and fuse panel cover, after market rear lca's, ac delete box setup (must include all needed parts (other than the obvious splicing needed) center link and passenger side spindle. front and rear coil springs prefer factory replacement moogs.
would be willing to deduct money for any of the priorly mentioned parts or possibly do a direct swap.
Thanks Gerry
BTW plz email your offers to LUTZ-103@COTC.Edu thanks, i don't get on thirdgen much anymore, probably going to get out of thirdgens all together after i tie up some loose ends on mine, in case someone is looking for a very moderate project. with tons of money and time already dropped in to her
I'm willing to do trades for parts i need for my iroc-z.....
Will sell outright for 125$ no personal checks, shipping at buyers expense.
currently need the driver side hush panel and fuse panel cover, after market rear lca's, ac delete box setup (must include all needed parts (other than the obvious splicing needed) center link and passenger side spindle. front and rear coil springs prefer factory replacement moogs.
would be willing to deduct money for any of the priorly mentioned parts or possibly do a direct swap.
Thanks Gerry
BTW plz email your offers to LUTZ-103@COTC.Edu thanks, i don't get on thirdgen much anymore, probably going to get out of thirdgens all together after i tie up some loose ends on mine, in case someone is looking for a very moderate project. with tons of money and time already dropped in to her
Last edited by flaming-ford; Aug 19, 2010 at 08:44 PM.
Thread
Thread Starter
Forum
Replies
Last Post
RedLeader289
Tech / General Engine
10
May 28, 2019 01:47 PM




