hey guys i have a comp roller cam for sale from my 350. all parts were bought and installed as a package from comp cams when i built my motor.

cam- 08-412-8 1200-5200
duration @.050 I-212/E-218
lift w/1.5 rocker I-487/E495
lobe separation 110 degres

lifters- 850-15 high energy roller lifters

springs- 986-16 1.430 inch dual spring
1.150 max coil bind
320 lbs spring rate

also i am keeping the locks,retainers and pushrods for my current set up. everything has less than 1000 miles and only 2 passes on it, like new. ill start at $375 obo for all of it. may separate shoot me some offers.

 

Let me know if you decide to sell cam sep.
Thanks
Chris

 

I will deffinatly consider it. Give it a couple days to se if anyone is looking for a mostly complete kit.

 

TTT. Anyone doing a carb conversion on a 305 tpi? This is what the tech at comp recomended when I originaly orderd this cam for my 89 5.0 tpi motor. I am open to trades. I'm looking for an adjustable jegster tourqe arm, a good 750 carb, one front non dimple gta wheel, open to other drive train parts.

 

TTT

 

Bringin this back again. Still have it all. Reasonable Offers.....

 

Interested in the springs and lifters. Give me a few minutes for some research and I'll make an offer.....

How about $140 shipped to 66216 for the lifters and springs?

I don't have any aftermarket drivetrain parts to trade, but do have most of an 89 GTA and lots of factory parts from an 89 TA if you are needing something specific for your car.

Feel free to PM me.

Thanks