Complete 350 shortblock for sale. 4 bolt main, factory windage tray, 1 piece rear main seal, provisions for factory roller cam setup. This motor is high miles (around 180K), but ran fine when it was pulled out. I personally drove the donor vehicle, there were no issues other than some oil leaks. This is the ideal 350 block to build from. $250.

ttt

pm sent

bump

bumpage

TTT

Do you still have this? What are you including with the short block? Hydraulic Roller?? What was it out of? Vortec Block??

Did it have a hydraulic roller cam and all it's pieces/parts in it or does it just have the provisions for one?? A lot of the TBI motors had the provisions but were flat tappet.

Let me know. I'm possibly interested and would be able to come see/pick-up.

Still have it, it's a non-vortec block from a '94 3/4 ton Suburban. I don't have the roller cam stuff, it just has the provisions for it. You're right, a lot of the TBI truck blocks had the provisions, but the 4 bolt main blocks are much harder to find. I have a few sets of heads, but they are nothing special at all.