[MD] Stock A-arms w/ Cut Stock Springs $30
05-04-2013, 12:20 PM
#1
Member
Thread Starter
iTrader: (1)
Join Date: Aug 2010
Location: MD
Posts: 486
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 Iroc-z
Engine: ls1
Transmission: t56
Axle/Gears: 3.42
Stock A-arms w/ Cut Stock Springs $30
Went to Tubular, No need for these anymore.
The springs were cut went I did my lsx swap as to lower the front end since the motor was aluminum. Id say it sat a good ~2" lower.
They were cut a little and then cooled to allow the metal to retain its strength. I daily drove with this setup for over a year without any problems or rubbing. One Bump Stock Is worn and should be replaced. Id also replace where the grease bushings.
.
Only looking to get $30 + Shipping OBO. Also selling the kmember in the lsx classifieds.
The springs were cut went I did my lsx swap as to lower the front end since the motor was aluminum. Id say it sat a good ~2" lower.
They were cut a little and then cooled to allow the metal to retain its strength. I daily drove with this setup for over a year without any problems or rubbing. One Bump Stock Is worn and should be replaced. Id also replace where the grease bushings.
.Only looking to get $30 + Shipping OBO. Also selling the kmember in the lsx classifieds.
Thread
Thread Starter
Forum
Replies
Last Post
Genopsyde
Engine/Drivetrain/Suspension Parts for Sale
3
10-07-2015 08:35 PM