I ordered the wrong rockers, these are for the Vortec head, they are non self aligning 1.5 ratio and have less than 10 miles on them. They were chafing against the stud which made the marks shown in the pictures. They are not damaged in any way. I am asking $200. shipped. Part # is 1037, you can get all info on Scorpion website.

[IMG][/IMG]

[IMG][/IMG]

[IMG][/IMG]

 

The chafing is common on the aluminum roller rockers like that. I had a set that did just that and used a carbide bit to machine all of them for clearance. It does not hurt performance at all. Just my 2 cents here to try and help assure people so you will have a good chance of selling these GLWS

 

Thanks I appreciate your input. Actually I believe it was from too short pushrods but at any rate they were not for my heads.
I am new on this forum but I have been on the Corvette Forum over 10 years and have sold a lot of parts over there.

 

bump

 

3/8 or 7/16 studs?

 

3/8