2.8 3.1 parts
Thread Starter
Junior Member
Joined: Nov 2005
Posts: 70
Likes: 0
2.8 3.1 parts
Goign to be building a 2.8 stroker, using a 3.1 crank, basically all I have is block and crank, lookign for anything anyone may have to hop this up a little, even possibly fuel injection
Joined: Aug 1999
Posts: 5,277
Likes: 469
From: RI
Car: 1984 Camaro Berlinetta
Engine: LT1
Transmission: T56 6-speed
Axle/Gears: 4.11 LS1 Rear End
2.8 V6 Fuel Injection -------->
Got one - Let me know if you need it.
Last edited by John in RI; Dec 26, 2006 at 10:45 PM. Reason: Remove pics
Member
Joined: Oct 2005
Posts: 388
Likes: 0
From: Youngstown, Ohio
Car: 1986 Olds Cutlass Supreme
Engine: 350
Transmission: 200-4R
Axle/Gears: good question...
I have an entire 2.8L MPFI engine sitting in my garage. Has just about everything except the harness and comupter. Small oil leak from RMS. It ran great. Its free, all you have to do is pick it up.
Youngstown, Ohio
Youngstown, Ohio 
Trending Topics
Junior Member
Joined: Feb 2005
Posts: 17
Likes: 0
From: Austin, Tx
Car: 88 Firebird
Engine: 350ci bored +.060"
Transmission: Turbo 350
Axle/Gears: 9" with 35 spline 4.10's and spool
I have the ECM and harness from a 2.8L with an automatic. The engine and tranny are gone, but the wiring and ECM are still around. $50 plus shipping if interested.
Joe
Joe
Member
iTrader: (1)
Joined: Dec 2005
Posts: 273
Likes: 0
From: Highlands, NJ
Car: 1986 Firebird
Engine: 3.4 outa 95' bird
Transmission: T5
Axle/Gears: 3.42 open rear
i have a set o heads for ya. has 2 burnt valves, but only has 58k miles on them. i have exhaust manifolds too.
Thread
Thread Starter
Forum
Replies
Last Post
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
20
Nov 14, 2015 12:02 AM