WTB Clutch/master cylinder bushing.
Thread Starter
Senior Member
iTrader: (1)
Joined: May 2007
Posts: 847
Likes: 0
From: Detroit
Car: 1989 Iroc-Z
Engine: 383 FFI
Transmission: TKO600
Axle/Gears: 3.42
WTB Clutch/master cylinder bushing.
I need the clutch/master cylinder bushing that is on all manual thirdgens. It should be on any stick thirdgen, V6,V8, RS/Z28/Iroc, anything. It's probably the same on all GM cars of that era but i'm not sure.
Thanks
~LMSkyliner
Thanks
~LMSkyliner
Joined: Aug 2006
Posts: 12,812
Likes: 110
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: WTB Clutch/master cylinder bushing.
the little nylon bushing that goes in the clutch masters pushrod loop and onto the pedal? i have a couple NOS ones if thats what you need.
Thread Starter
Senior Member
iTrader: (1)
Joined: May 2007
Posts: 847
Likes: 0
From: Detroit
Car: 1989 Iroc-Z
Engine: 383 FFI
Transmission: TKO600
Axle/Gears: 3.42
Re: WTB Clutch/master cylinder bushing.
But my dad just found one at work and he can get it for practically nothing so im afraid i'm going to have to pass now
Last edited by LMSkyliner; Jul 24, 2008 at 01:10 PM.
Senior Member
iTrader: (7)
Joined: Dec 2007
Posts: 618
Likes: 0
From: Williamstown, NJ
Car: '98 Mustang GT
Engine: '03 4.6L
Transmission: T45
Axle/Gears: DK
Joined: Dec 1999
Posts: 3,544
Likes: 19
From: WI,USA
Car: 89 FORMULA 350, 91 Z28 Convertible
Engine: ls1, LB9
Transmission: t56, Auto
Axle/Gears: S60/ 3.73
Re: WTB Clutch/master cylinder bushing.
better get it new from the dealer. they look ok and then your at a light when the rod pops off!
Thread
Thread Starter
Forum
Replies
Last Post