[CA] HELP!!!!
Thread Starter
Want a title? Post!
Joined: Sep 2009
Posts: 0
Likes: 0
From: Southern California
Car: '89 Camaro
Engine: V8 305ci TBI
Transmission: 4sp Automatic
Axle/Gears: Stock
HELP!!!!
my camaro needs a new vacuum diaphragm motor, and a bracket for the ignition coil. these parts are not exactly on every parts store's counter. where could i find these parts besides a junkyard? any websites that sell odd parts like this?
Senior Member
Joined: Nov 2008
Posts: 311
Likes: 0
From: Ft Campbell, KY
Car: 1991 Camaro RS/Z28
Engine: 357 Edelbrock Intake & Holley Carb
Transmission: WC T-5
Axle/Gears: whatever stock is
Re: HELP!!!!
vacuum diaphragm motor??
I have that coil bracket on my old 305, I don't need it anymore.
I have that coil bracket on my old 305, I don't need it anymore.
Thread Starter
Want a title? Post!
Joined: Sep 2009
Posts: 0
Likes: 0
From: Southern California
Car: '89 Camaro
Engine: V8 305ci TBI
Transmission: 4sp Automatic
Axle/Gears: Stock
Re: HELP!!!!
really? i could really use it. i'd pay you for it too, just because all the camaros in junkyards in my area are picked clean. and i looked on ALLDATA, the vacuum diaphragm motor is the little round piece located on the intake canister right above the thermac (tube) that hooks up to the exhaust on the right hand side (recirculates hot air into the intake for emissions purposes)
heres my email: normalearthhuman@yahoo.com
heres my email: normalearthhuman@yahoo.com
Senior Member
Joined: Nov 2008
Posts: 311
Likes: 0
From: Ft Campbell, KY
Car: 1991 Camaro RS/Z28
Engine: 357 Edelbrock Intake & Holley Carb
Transmission: WC T-5
Axle/Gears: whatever stock is
Re: HELP!!!!
Are you talking about the piece that screws into the manifold right behind the TBI or carb?
Thread Starter
Want a title? Post!
Joined: Sep 2009
Posts: 0
Likes: 0
From: Southern California
Car: '89 Camaro
Engine: V8 305ci TBI
Transmission: 4sp Automatic
Axle/Gears: Stock
Re: HELP!!!!
no. it is tac welded to the air box (canister) it's alright though, i talked to one of my instructors about it and we figured out a solution. i just need that coil bracket
Senior Member
Joined: Nov 2008
Posts: 311
Likes: 0
From: Ft Campbell, KY
Car: 1991 Camaro RS/Z28
Engine: 357 Edelbrock Intake & Holley Carb
Transmission: WC T-5
Axle/Gears: whatever stock is
Re: HELP!!!!
OK, I'll try to remember to pull it off the engine tomorrow after some other stuff.
Thread Starter
Want a title? Post!
Joined: Sep 2009
Posts: 0
Likes: 0
From: Southern California
Car: '89 Camaro
Engine: V8 305ci TBI
Transmission: 4sp Automatic
Axle/Gears: Stock
Trending Topics
Senior Member
Joined: Nov 2008
Posts: 311
Likes: 0
From: Ft Campbell, KY
Car: 1991 Camaro RS/Z28
Engine: 357 Edelbrock Intake & Holley Carb
Transmission: WC T-5
Axle/Gears: whatever stock is
Re: HELP!!!!
Landlord didn't have the shop gate open where my car and old engine are at tonight.




