A continuation of my series of threads. Looking for these parts for my '88 IROC/engine build.

Headers for Gen I SBC's (prefer long tubes)
600-700CFM carb w/ mechanical secondaries (electric choke, Holley preferred)
Forged 350 crankshaft (mine is scored, previous owner spun a bearing, debating if turning it would be cheaper)
4th gen rear end w/ disc brakes
10-bolt 3.73 posi unit

That's all for now, I'll update this depending on what I get and what I remember I need.

Please check my other threads:

Interior:
https://www.thirdgen.org/forums/inte...ts-camaro.html

Exterior:
https://www.thirdgen.org/forums/exte...ior-parts.html

 

I have 3 long tubes, no idea what brand. Two drivers side headers, both in good shape, one pass side. Pass side..had a hole, I welded it shut. The collector flange looks like the previous owner tried eating it; its..ripped off. Could weld on the collector from the third header tho. All are a bit rusty..

Did not fit properly on my 86 t/a, but fit fantastic when flipped upside down and through the hood!
Asking $30+shipping from southeast ks

 

Got pics?

 

The only ones I have now are still on the car, once I'm off work I could post more. Not sure if they were for a truck er a g body er whatnot

 

They're all like this. Only the pass side one has the collector ripped

 

Hate to revive a dead thread but I have a set of long tubes and a full exhaust for sale. I also have a 500hp gen 1 sbc 383 for sale. Let me know if u need anything

 

Have a Holley or Edelbrock 600 if I remember right, needs to be rebuilt but I have the rebuild kit