Like a fool, I forgot to grab one from the 02 my local pick and pull had and by the time i got back it was crushed. So, trying to find one. If the bushings/seal are wiped that's even better. Mocking up a Speedo drive setup in my non torque arm tailshaft soni can perfect the measurements for my swap.

Still looking

If you use the holley/jhooker crossmember you dont need it. has the torque arm mount on the crossmember itself.

I appreciate the insight. If I can't find one by the time the car is built I'll go that route. The tailshaft housing shouldn't be more than $50, so just trying to avoid unnecessary costs in the build at the moment. But if all else fails, that's a good option.

Found one at a pick and pull while out of town on business.