Hello Everyone,

I will attempt to run wires to a 16pin DLC connector. In order to use a Scan Tool.

My manual indicates the following. Think it is that simple?

Apparently all the scan tool looks for is an Output/Field Service Enable signal and a Serial Data signal.

DLC Pin out as described in manual.
Pin 2 = Serial Data (Class 2)
Pin 4 = Ground
Pin 5 = Ground
Pin 6 = Output/Field Service Enable
Pin 9 = Serial Data
Pin 16 = 8+ volts

Can anyone comment on the "Class 2" note. I only see one Serial data output from my computer. I intend to run this wire to Pin 9 of a DLC connector. Likewise the service enable wire to Pin 6 and so forth.

Any further insight would be greatly appreciated.

Thank You,
Gus

This **** is still over my head, hopefully not for long, but here are some links to check out if you haven't already that relate:

http://moates.net/gmecm/

http://www.winaldl.webhop.net/

These both go into detail on making the cable you describe.

Good Luck!