Ive got a 305 engine thats doin pretty good. but im going to switch up for a 350, i know that you can get pretty good HP out of using 305 heads on a 350, but ive never seen anything about what kind of cams and intakes to use. ive got my 305 heads port and polished to 58cc, i want to run a high rpm setup like a performer rpm intake and a high rpm cam, you have any suggestions on what to use??? ive got my 350 block flat decked and bored 30 over but im not sure on what else im gonna do yet... cost doesn't matter too much, because i want to do it right.

 

I am putting a performer RPM on my new motor... Only reason I picked this intake is because I snatched it up for $25 a swap meet...