Will these V8 parts work on my 2.8?
Thread Starter
Joined: Feb 2003
Posts: 1,229
Likes: 5
From: Albuquerque, NM
Car: 1966 El Camino Custom
Engine: 350
Transmission: 200R4
Axle/Gears: 3:73 12 bolt with Brute Strength
Will these V8 parts work on my 2.8?
I have some V8 performance parts left over from my former IROC. Does anyone know if they will fit my 1988 2.8 Ralley Sport?
GTA aluminum driveshaft
Spohn 700R4/T5 Crossmember and torque arm
I'm putting this on the Swap Board because I figure many people have done the V6 to V8 swap and know which parts were retained. For instance, when you did your swap, were you able to retain the V6 driveshaft? How about the V6 crossmember? The answer to those two questions will answer my question.
GTA aluminum driveshaft
Spohn 700R4/T5 Crossmember and torque arm
I'm putting this on the Swap Board because I figure many people have done the V6 to V8 swap and know which parts were retained. For instance, when you did your swap, were you able to retain the V6 driveshaft? How about the V6 crossmember? The answer to those two questions will answer my question.
Last edited by wesilva; Nov 30, 2006 at 12:57 PM.
Thread
Thread Starter
Forum
Replies
Last Post
hectre13
Engine/Drivetrain/Suspension Parts for Sale
7
Aug 26, 2015 08:17 AM
1992 Trans Am
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 8, 2015 08:16 PM