K frame replace?
Thread Starter
Junior Member
Joined: Dec 2006
Posts: 6
Likes: 0
K frame replace?
i built a 350 small block...to put in my "92 rs.. the headers im using are hooker comp long tube headers..my ? is does anyone know how to go around replacing the k frame...?
----------
headers wont fit unless i notch the k frame or buy a aftermarket one...
----------
headers wont fit unless i notch the k frame or buy a aftermarket one...
Last edited by clean92; Dec 24, 2006 at 03:43 PM. Reason: Automerged Doublepost
Moderator
Joined: Jul 1999
Posts: 17,269
Likes: 170
From: 51°N 114°W, 3500'
Car: 87 IROC L98
Engine: 588 Alcohol BBC
Transmission: Powerglide
Axle/Gears: Ford 9"/31 spline spool/4.86
Support the engine from the top or completely remove it.
Disconnect the brake lines and anything else attached from the body to the k-member. Disconnect the brake lines at the flex hoses.
Disconnect the lower ball joint from the spindle.
Unbolt the 6 bolts from underneath and drop the old k-member down. The k-member and a-arms will come out as one assembly.
Disconnect the brake lines and anything else attached from the body to the k-member. Disconnect the brake lines at the flex hoses.
Disconnect the lower ball joint from the spindle.
Unbolt the 6 bolts from underneath and drop the old k-member down. The k-member and a-arms will come out as one assembly.
Member
iTrader: (2)
Joined: May 2005
Posts: 334
Likes: 1
From: Palatine, IL
Car: 87 iroc
Engine: 454 .030 over
Transmission: th-350
Axle/Gears: 9 bolt
Support the engine from the top or completely remove it.
Disconnect the brake lines and anything else attached from the body to the k-member. Disconnect the brake lines at the flex hoses.
Disconnect the lower ball joint from the spindle.
Unbolt the 6 bolts from underneath and drop the old k-member down. The k-member and a-arms will come out as one assembly.
Disconnect the brake lines and anything else attached from the body to the k-member. Disconnect the brake lines at the flex hoses.
Disconnect the lower ball joint from the spindle.
Unbolt the 6 bolts from underneath and drop the old k-member down. The k-member and a-arms will come out as one assembly.
Thread
Thread Starter
Forum
Replies
Last Post
