Clutch master hangup
Thread Starter
Junior Member
Joined: Dec 2006
Posts: 33
Likes: 0
From: Memphis, TN
Car: 1989 Camaro RS
Engine: LT1 from '96 Corvette
Transmission: T56
Axle/Gears: 3.42 diff
Clutch master hangup
I bought a new hydraulic setup for my LT1/T56 swap into my 89 RS. I got the setup for a '93 Z28.
Everything bolts up fine, but the clutch pedal pin and master cyl. rod don't match in terms of diameters. Neither my old bushing nor the new one fit together just right with the new setup.
Anyone had this issue, and know of a good solution?
Everything bolts up fine, but the clutch pedal pin and master cyl. rod don't match in terms of diameters. Neither my old bushing nor the new one fit together just right with the new setup.
Anyone had this issue, and know of a good solution?
Thread
Thread Starter
Forum
Replies
Last Post