machining engine block
Thread Starter
Junior Member
Joined: Apr 2009
Posts: 86
Likes: 0
From: Austin Tx
Car: 1992 Camaro RS
Engine: 350 .060 over
Transmission: stock
Axle/Gears: stock for now
machining engine block
I have a SBC 350 that im rebuilding. I pulled it out of a 79' GMC truck so its a little worn and dirty. I figure i should take it to a machine shop to get the cylinders re-honed. Should i get it resurfaced too? does this make a difference in performance?
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
Re: machining engine block
What machining needs to be done will depend on what condition the block is in.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Mar 5, 2017 06:37 PM
