Cold air intake after swap?
Thread Starter
Member
iTrader: (2)
Joined: Aug 2009
Posts: 123
Likes: 0
From: Kentucky
Car: 1991 Camaro Z28
Engine: 6.2L LS3 to come
Transmission: 4L60E LVL2 700rwhp
Axle/Gears: 3.73
Cold air intake after swap?
Anyone have any pictures of their CAI after the swap? I'm looking for a stainless intake to clean up the engine bay a bit.
Joined: Sep 2009
Posts: 3,776
Likes: 101
From: Spokane WA
Car: 92 Lingenfelter Z28 articwhite
Engine: Aluminum 615BBC
Transmission: Th400wbrake/curri entps9" locker
Axle/Gears: 4.11/4.30/4.56
Re: Cold air intake after swap?
dont look at the dust!
this is a 92 Z28. and my CAI it will look stock when the hood is up.
and use stock filters..
takes air in from the fog lights intakes (lights left in place) also..
will get a better shot.. to show both sides are done the same.
Works fantastic..gess i could have buffed the alum sheet out..lol
all this is one piece. and comes out or in as one piece.. fits any 3rd gen with the Y intake tubes..as it's just the from air box thats been worked on..
this is a 92 Z28. and my CAI it will look stock when the hood is up.
and use stock filters..
takes air in from the fog lights intakes (lights left in place) also..
will get a better shot.. to show both sides are done the same.
Works fantastic..gess i could have buffed the alum sheet out..lol
all this is one piece. and comes out or in as one piece.. fits any 3rd gen with the Y intake tubes..as it's just the from air box thats been worked on..
Last edited by articwhiteZ; Sep 24, 2009 at 10:20 AM.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
kyle5647
Tech / General Engine
1
Aug 15, 2015 11:56 PM