Junk Yard ?'s
#1
Member
Thread Starter
Join Date: Feb 2001
Location: Sewer City, Ia.
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 RS
Engine: 5.0
Transmission: Auto
Junk Yard ?'s
Hey everyone, I need to replace my 91 305 TBI/4spd Auto. I want a 350, can I get one from any 91 GM truck and will it work? What will the yard let you take with the engine, TBI, Prom, all the accesories, etc? Shouldn't everything be ok emission-wise. Also how much should I expect pay for it and what are they rated at for HP.
------------------
91 RS Conv. 305 tbi no cat. 16" IROC rims, whiteface guages. More soon.
Here's my web page http://www.fbody.com/members/91RSCONV/
------------------
91 RS Conv. 305 tbi no cat. 16" IROC rims, whiteface guages. More soon.
Here's my web page http://www.fbody.com/members/91RSCONV/
#2
I am sorry I can't answer your post... I just wanted to say u have a very sweet Camaro. Did the hood come with the car or is that a mod?
Someone will answer your post...hang in there!
Someone will answer your post...hang in there!
#3
Junior Member
Join Date: Feb 2001
Location: Elmira, NY, USA
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
If you jump over to the TBI board someone over there swapped a vortec 350 out of a 96-98 chevy truck. He had to use a vortec intake and TBI adapter. Do a name search on badbrd383 I think. I believe this put him in the low 14s running the stock 305 chip. Vortec motors in my area are going for about a grand depending on the miles. Check it out, might be one way to go.
[This message has been edited by ahusted (edited July 29, 2001).]
[This message has been edited by ahusted (edited July 29, 2001).]
#4
Member
iTrader: (4)
Join Date: Jun 2001
Location: new phila, oh
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 RS
Engine: LS1
Transmission: T56
Axle/Gears: 3.73 9 bolt
Most junk yards in Ohio I have been to will sell the complete engine. That is wiring, computer, and accessories. I didnt buy a truck motor, but I got an LT1 and only paid 950 for it with anything i wanted off the car that needed to go with the motor. I would imagine that since the truck you are getting the motor out of was emissions legal your car should be.
------------------
check out my site: <A HREF="http://www.geocities.com/joecool_2u" TARGET=_blank>
http://www.geocities.com/joecool_2u
</A>
Project LT1 install has begun.
------------------
check out my site: <A HREF="http://www.geocities.com/joecool_2u" TARGET=_blank>
http://www.geocities.com/joecool_2u
</A>
Project LT1 install has begun.
#5
Supreme Member
Join Date: Feb 2001
Location: North Canton, Ohio
Posts: 2,033
Likes: 0
Received 2 Likes
on
1 Post
Car: 1982 Firebird
Engine: sbc 307
Transmission: 200
rickyzZ28, where did you get your LT1? Have you ever been to Greentown Auto Parts? My dad owns it, so ya know, I got some parts there, hehe.
#6
Junior Member
Join Date: Jul 2001
Location: Central SC USA
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
I agree he does have a sweet camaro. Especially like the hood!
<font face="Verdana, Arial" size="2">Originally posted by multi-tasking:
I am sorry I can't answer your post... I just wanted to say u have a very sweet Camaro. Did the hood come with the car or is that a mod?
Someone will answer your post...hang in there!</font>
I am sorry I can't answer your post... I just wanted to say u have a very sweet Camaro. Did the hood come with the car or is that a mod?
Someone will answer your post...hang in there!</font>
#7
Member
iTrader: (4)
Join Date: Jun 2001
Location: new phila, oh
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 RS
Engine: LS1
Transmission: T56
Axle/Gears: 3.73 9 bolt
Dont think that I have been there but I got my LT1 from a 93 Z28 at a junk yard in Dover OH called Wayne-Hayes on Rt 516.
------------------
check out my site: <A HREF="http://www.geocities.com/joecool_2u" TARGET=_blank>
http://www.geocities.com/joecool_2u
</A>
Project LT1 install has begun.
------------------
check out my site: <A HREF="http://www.geocities.com/joecool_2u" TARGET=_blank>
http://www.geocities.com/joecool_2u
</A>
Project LT1 install has begun.
Trending Topics
#8
Member
Join Date: Nov 2000
Location: mayfield, OH
Posts: 323
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82 Trans am
Engine: Twin turbo 350
Transmission: T-56
Emissions would only be a problem if your state required a visual inspection. Then if you have a motor that never came on your car, unless the attendant is a moron, you wont pass. Here is how emissions goes in my county in ohio:
1. visual check for a cat. as long as there is something resembling a cat (ie, gutted w/ a pipe through it) it will pass.
2. sniffer test. the general test where they run your car at a certain speed and check for co, hc, etc.
2 loopholes:
- if your car is manufactured more than 25 years ago, it doesnt need any emissions.
- if you spend 300 (or 500 cant remember) bucks on getting the car emissions legal it gets an automatic pass. the trick there: get a friend that works at an auto shop to print up some bogus reciepts and use those.
It may be similar or completely different elsewhere, i'm not certain.
[This message has been edited by slickrock55 (edited August 04, 2001).]
1. visual check for a cat. as long as there is something resembling a cat (ie, gutted w/ a pipe through it) it will pass.
2. sniffer test. the general test where they run your car at a certain speed and check for co, hc, etc.
2 loopholes:
- if your car is manufactured more than 25 years ago, it doesnt need any emissions.
- if you spend 300 (or 500 cant remember) bucks on getting the car emissions legal it gets an automatic pass. the trick there: get a friend that works at an auto shop to print up some bogus reciepts and use those.
It may be similar or completely different elsewhere, i'm not certain.
[This message has been edited by slickrock55 (edited August 04, 2001).]
#9
Senior Member
Join Date: Mar 2001
Location: Silverhill,Al
Posts: 838
Likes: 0
Received 1 Like
on
1 Post
Car: 92 Camaro RS
Engine: 305 TBI
Transmission: T-5
Get a 350 engine from a car if you can, the ones in cars have a roller cam. The trucks all use flat-tappet cams.
------------------
92 Camaro RS 5.0 5-Speed (Quasar Blue)
T-Tops
14" Open Air Cleaner
3.08 Posi-trac
Edelbrock TBI Intake
Crane cam
Ported & polished stock heads 3 angle valve job
HyperTech Chip
SLP Headers (Ceramic Coated)
UltraFlo cat-back exhaust
74 Dodge Dart Sport 360 (11.2 1/4 mile)
2000 Dodge 1500 Ram Sport
------------------
92 Camaro RS 5.0 5-Speed (Quasar Blue)
T-Tops
14" Open Air Cleaner
3.08 Posi-trac
Edelbrock TBI Intake
Crane cam
Ported & polished stock heads 3 angle valve job
HyperTech Chip
SLP Headers (Ceramic Coated)
UltraFlo cat-back exhaust
74 Dodge Dart Sport 360 (11.2 1/4 mile)
2000 Dodge 1500 Ram Sport
#10
Member
Thread Starter
Join Date: Feb 2001
Location: Sewer City, Ia.
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 RS
Engine: 5.0
Transmission: Auto
Thanks for the help everyone.
Dartbyu, what cars came with a 350/tbi during 1991? Caprice, any others? I need the swap to be as simple and inexpensive as possible.
Dartbyu, what cars came with a 350/tbi during 1991? Caprice, any others? I need the swap to be as simple and inexpensive as possible.
Thread
Thread Starter
Forum
Replies
Last Post