Whats up guys? Well hopefully tomorrow i will be dropping my new motor in i just needed some help...what is the easiest way to get it in?? The transmission is still in the car thats why im asking..any help would be great thanks.

 

There is no easy way, you just have to do it.

 

slow and easy, don't rush the process. Line up the tabs/holes on the bellhousing, and work methodically. make sure you hook up the groundwire.. I watched an emergency brake line get bright red and droop when they forgot to do so in a Ford engine swap I was idly watching.

 

ha ha well i dont even have my wiring in yet im just putting the motor in to clear up my garage...hopefully it goes will

 

Well attempt number 1 fail!!! i could not get the torque converter to go into the shaft..and transmission fluid was all over the place so i called it quits...should i just pull the transmission out?