advice needed anyone?
Thread Starter
Junior Member
Joined: Nov 2009
Posts: 30
Likes: 0
From: St louis mo
Car: 1991 z28 Convertable
Engine: Tpi 350
Transmission: 700r4
Axle/Gears: 273 built ten bolt posi
advice needed anyone?
ok i have a 91 z28 just wonderin if the factory cam from the original 305 tpi was only specified to work with the map setup,also im putting in 89 k5 5.7 which i know is not a roller engine would this motor work fine with the map sensor also i have a stage two chip dont know if that helps any advice?
Thread
Thread Starter
Forum
Replies
Last Post