Can it be returnrd to the LT motor?
Thread Starter
Joined: Feb 2006
Posts: 1,265
Likes: 0
From: Sacramento Ca
Car: 86 Trans am, 91 Camaro RS
Engine: 355 Sbc, nothin yet
Transmission: 700r4- both
Can it be returnrd to the LT motor?
I have an LT4 hot cam sitting in my parts pile, and was curious to kno.... If I modded that little rod on the front of the cam to use in an L98, can I still turn around and put that same cam back into an LT1 motor? How difficult would it be to pull that rod back out to make it useable? Any insight would be appreciated
Joined: Jul 2007
Posts: 358
Likes: 2
From: Waukesha, WI
Car: 86 Camaro Z28
Engine: LT1 200cc Ai heads and cam
Transmission: T56
Axle/Gears: 4.10:1 Zexel Torsen
Re: Can it be returnrd to the LT motor?
it'll work on the 93-94 lt1. isn't the dowel rod pressed in? if so pull it out and save it, then just use one from another cam
Thread Starter
Joined: Feb 2006
Posts: 1,265
Likes: 0
From: Sacramento Ca
Car: 86 Trans am, 91 Camaro RS
Engine: 355 Sbc, nothin yet
Transmission: 700r4- both
Re: Can it be returnrd to the LT motor?
It's pressed in since I ran it on my motor... Now I'm gonna sell it but I wanna be sure I'm selling a useable item to my boy. I'm sure it was a certain length for a reason when it was made. But since pressing it in further, I don't know if can be salvaged to work on an LT1 motor again.
Thread
Thread Starter
Forum
Replies
Last Post