wiper motor clearance issues
#1
Junior Member
Thread Starter
Join Date: Aug 2015
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 TA
Engine: 496
Transmission: T400
Axle/Gears: 373
wiper motor clearance issues
Has anyone ever relocated or found a slimmer wiper motor or a solution when the factory wiper motor just won't fit. After putting stud girdle's on and adding a spacer I do not have the room for the original wiper motor and I must have one for safety inspection. I am at a loss hoping for some advice. Thanks in advance.
#2
TGO Supporter/Moderator
iTrader: (12)
Join Date: Jul 1999
Location: SALEM, NH
Posts: 11,723
Likes: 0
Received 89 Likes
on
75 Posts
Car: '88 Formula, '94 Corvette, '95 Bird
Engine: LC9, 355" LT1, LT1
Transmission: T5, Zf6, 4L60E
Axle/Gears: 3.42, Dana44 3.45, 3.23
Re: wiper motor clearance issues
Has anyone ever relocated or found a slimmer wiper motor or a solution when the factory wiper motor just won't fit. After putting stud girdle's on and adding a spacer I do not have the room for the original wiper motor and I must have one for safety inspection. I am at a loss hoping for some advice. Thanks in advance.
My wiper motor is miles away..
-- Joe
Thread
Thread Starter
Forum
Replies
Last Post
mdtoren
Tech / General Engine
0
08-16-2015 05:45 PM