Vortec TPI
#1
Senior Member
Thread Starter
Join Date: Mar 2011
Location: dothan, al
Posts: 668
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 pontiac trans am
Engine: None
Transmission: None
Axle/Gears: 10 Bolt
Vortec TPI
Alright so it looks like I maybe having to put an engine in my car, just blew my 305........... finally lol. So here is what I'm looking at doing, let me know how this sounds or anything else I need, thanks:
Accel 26 PPH fuel injectors, Aeromotive AFPR, Edelbrock vortec TPI intake manifold, Sealed Power complete engine rebuild kit w/ .030 over pistons, FAST TPS sensor and IAC valve, Hypertech chip, March underdrive pulley kit, MSD plug wires, 6AL kit, blaster coil, distributor, wiring harness, Powermaster alternator and starter, SLP intake runner and air foil, Energy Suspension engine and transmission mounts, Vortec heads and of course a 350 block. The block and heads I already have. I will be using my serpentine setup and exhaust manifolds off my 305 for the 350, I will also be selling parts from both engines to fund this project. I will post back Sunday and see what I am going to be doing, please post any suggestions as I will need all the help I can get. Thanks!
Accel 26 PPH fuel injectors, Aeromotive AFPR, Edelbrock vortec TPI intake manifold, Sealed Power complete engine rebuild kit w/ .030 over pistons, FAST TPS sensor and IAC valve, Hypertech chip, March underdrive pulley kit, MSD plug wires, 6AL kit, blaster coil, distributor, wiring harness, Powermaster alternator and starter, SLP intake runner and air foil, Energy Suspension engine and transmission mounts, Vortec heads and of course a 350 block. The block and heads I already have. I will be using my serpentine setup and exhaust manifolds off my 305 for the 350, I will also be selling parts from both engines to fund this project. I will post back Sunday and see what I am going to be doing, please post any suggestions as I will need all the help I can get. Thanks!
#2
Supreme Member
iTrader: (2)
Join Date: Nov 2000
Location: California
Posts: 1,295
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Camaro Convertible
Engine: 355
Transmission: 700r4
Re: Vortec TPI
I say go for it. Buy my forged 355 for your base Personally I say go AFR's over vortec, not as limiting as far as intakes and all.
Thread
Thread Starter
Forum
Replies
Last Post
Fast355
DFI and ECM
14
12-02-2016 06:33 PM
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
08-12-2015 03:41 PM