rookie quest
Thread Starter
Joined: Sep 2011
Posts: 1,036
Likes: 22
From: nc
Car: 91RS
Engine: carb'd 357 vortec
Transmission: 700r4
Axle/Gears: 3.42 posi
rookie quest
V6 to v8 rs with 700r4 and I'm trying to figure out y the tranny crossmember for my v8 isn't working out! Then I was going to connect a v6 tranny mount to my v8 tranny and can't see a difference in any picture between the mounts. What am I doing wrong? How do I connect my v8 to the v6 crossmember? Thx
Joined: Apr 2005
Posts: 7,736
Likes: 14
From: Not in Kansas anymore
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Thread Starter
Joined: Sep 2011
Posts: 1,036
Likes: 22
From: nc
Car: 91RS
Engine: carb'd 357 vortec
Transmission: 700r4
Axle/Gears: 3.42 posi
Re: rookie quest
got it! found it on ebay I don't know why I didn't think about keeping it I didn't think I needed it. but I got it for $35 but here it is.
https://www.thirdgen.org/forums/atta...ber-mounts.jpg
the little short one in the middle. thx though
https://www.thirdgen.org/forums/atta...ber-mounts.jpg
the little short one in the middle. thx though
Thread
Thread Starter
Forum
Replies
Last Post