86 Camaro Z28
Thread Starter
Junior Member
iTrader: (1)
Joined: Nov 2006
Posts: 29
Likes: 0
From: New Jersey
Car: '11 Explorer Limited
86 Camaro Z28
Hi everyone, I'm getting ready to remove my K-Member out of my 86 Z28 for blasting and powder coating and have a quick question. I purchased and motor suspension system which sits along both inner fenders and am looking for the correct support points on the motor since it may be like this for a few weeks till I get it back from powder coating. It's a 305 4 barrel carb car. Any suggestions would be greatly appreciated !!!!
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Most any 3/8" bolt will do - intake manifold, exhaust manifold, ends of head, etc.
Thread
Thread Starter
Forum
Replies
Last Post
CarGuyDennis
Organized Drag Racing and Autocross
137
Dec 6, 2016 11:02 PM
GVMV
Engine/Drivetrain/Suspension Wanted
1
Aug 16, 2015 08:01 PM