On the Edelbrock TES Headers system for the single-cat setup, does it include everything you need from the motor to the stock position for the cat? Does it bolt right up to the cat, or do I need to buy something else with it? Thanks.

I know the TES systems for our cars include the y-pipe that goes from the headers to the cat, and according the Edelbrock's website, they come with all the hardware necessary for installation.

Jason

Yes, they include everything, all you need to install them is some tools and A LOT of patience.

------------------
1987 Chevy Camaro IROC-Z
L98 TPI 350 (5.7L)
TH 700R-4 Transmission with 2.77:1 Rear End

Current Mods: Edelbrock TES 1 5/8" Headers, Hooker Aerochamber Cat-Back System, Performance Resource Chip with 160* Thermostat, Accel Ignition Components, K&N Filters, All Free Mods, Falken ZIEX Z-Rated Tires.

Best ET : 14.3 @ 97mph
(corrected for elevation)

everything you need comes with it if you have a OEM y-pipe that slips onto the cat

Yes, it comes with everything that you need. I am putting the TES on my 305ci lg4 right now and plan to run it at the strip on Satruday. I will let everyine know the results.

Yeah.. the passenger side is the hardest.

------------------
Black 90 IROC, L98, A4, 323 gear. SuperRamed 406 in the works!

LISTEN CAREFULLY!!!!!

I put on the Edelbrock TES headers on my 82 z28 yesterday, and i mean exactly what i said, YESTERDAY! from 8 am to 8 PM! non stop, now this is a PAIN in the *** ! JUST TAKE YOUR TIME, it will not go fast, you will have to remove your bolts holding the AC COMPRESSOR on your manifolds, which is a pain! and watch your dip stick tube.. I thought i would notice a big difference, i really didnt.. its just alot of work guys, be patient!