Do I want straight boots or angled boots?

------------------
We need Perry Mason

 

Angled. 90º.

Tim

------------------
TRAXION's 1990 IROC-Z
Best Time = 12.587 @ 107.97mph (1.710 60ftr) on the long runner setup.
All Natural. No Force. No Drugs. Stock Bottom End. Stock Body Panels. Stock Wheels. No Weight Reduction.
Gunning for NA 11's with the MiniRam II and Hooker LT Headers.
-=ICON Motorsports=-
Moderator: PROM board at thirdgen.org

 

I suggest that you get a good set of wire looms. Tie your wires down so that they don't wiggle around. I ran my wires over the top side because there was little clearence between the header and the back side of the head. Watch out for your starter, temp sensor, fan switch and knock sensor wires.

------------------
Nor Cal Mike
Red 84 Z28, stock L82 350, L69 carb, intake, and air cleaner
5 Spd, 3:73 Posi, 1 5/8" SLP headers, 3"cat connected to
stock L69 exhaust, KYB's
Some are faster but mine's fast enough.

 

I agree: 90-degree boots and wire looms that route over the valve covers. I installed the Made For You centerbolt v.c. looms sold in Summit or Jegs and they work great. Wires still look brand new after 2 years. You can see some pix at:
http://users.erols.com/gcwestph/Headers.html

of my Hooker headers and wire looms. If I had to do it again, I would've cut the AIR tubes off before having the headers coated since they get in the way trying to change the plugs or any other work in that area.

Greg