Here's what my headers cam with.......

Not at all what I got from SLP...

Dunh, dunh, dunnnnnhhhhh.........the plot thickens. I think SLP may have sold the engineering for there headers

so has anybody been able to locate a set of headers like these that i can buy, i don't care if they are accel or slp, i just really like them they are something difernet. hehe

Just got my headers coated here in calgary alberta. They look pretty good. $150 cdn not too shabby ehh.[IMG]header.jpg[/IMG]

Just got my headers coated here in calgary alberta. They look pretty good. $150 cdn not too shabby ehh.

what kind of headers are thoes and did you send them out to somewhere or was it a local shop?

They are hedmans. Its the only shop here in calgary that does them. They are coated in and out im impressed.

thoes are the ones i want!!! did u buy them and then send the headers to the shop or did u order it through the shop? i can see if some shops get mad if you dont buy it through them. they look killer!! did you get the y pipe for them, and did you get that coated?

I bought the headers and y-pipe at a different place and brought them to Top Gun Coatings. Header part # is 68470 and y-pipe is
#17470.

thanks man.. im gunna buy the headers and y pipe from jegs and then find a place that coats headers

Does anyone know how Jet Hot coats the inside? I watched the video on how they coat them...and they actually spray it on. I was thinkin "how do they coat the inside if it's sprayed on?"

Not very well. Well, I dont know if thats always the case, but with my hooker lt's they look great, but they coated them with the removable primary installed and I pulled it out and inside the pipes arent coated very well It appears that they probably flow/spray it through somehow and what it gets it gets and what it doesnt it doesnt. The outsides and what you can see from the ends look great though.

Ben

I dont know how JET HOT does it but if they try and spray it they wont get 100 f the inside.

I use a nylon tube on a pressure pot to get 100 of the inside.
The end is caped off and there are pin holes in the tub 360* around it to spray outward as I pull the tub back out of the headers. works great !!

1982chevycamaroz28.....You said those are the hooker 2210's right. Coated. correct?

The 2210s are an exact part correct? so they all have the same primary size?

Thx. I am pretty sure this is a stupid question, but I need to get some very soon so I want to get all the confution out of my head before I fork over the $. Thanks again

bump....

I need to get these header Q's answered soon. THX

check out the sticky at the top of this board.