ARP Bolts
Thread Starter
Member
Joined: Jul 2001
Posts: 135
Likes: 0
From: Camp Lejeune, NC
ARP Bolts
Just getting ready to install my SLP headers and wanted to know if the ARP stage 8 locking bolts were hard to put on. I have heard that you have to file them down some. Is that true?
Supreme Member
Joined: Jan 2001
Posts: 1,746
Likes: 0
From: Tucson, AZ
Car: 1991 Z-28
Engine: Can you say stroke?!?!
Transmission: 700-r4
Axle/Gears: 3.42
You MIGHT have to file some of the moon shaped washers to make them fit. I had to but it was only on 2 I think. It was just because some of the welds we too large.
------------------
'91 Z-28 5.7, SLP 1 3/4 headers, 4 inch Mufflex/Flowmaster cat back, gutted cats, Edelbrock intake, 8.5mm Jacob wires, MSD Blaster coil, S&W subframe setup, Jacob Pro Street Ignition, complete Kenwood system.
------------------
'91 Z-28 5.7, SLP 1 3/4 headers, 4 inch Mufflex/Flowmaster cat back, gutted cats, Edelbrock intake, 8.5mm Jacob wires, MSD Blaster coil, S&W subframe setup, Jacob Pro Street Ignition, complete Kenwood system.
Thread
Thread Starter
Forum
Replies
Last Post
355tpipickup
Tech / General Engine
9
Sep 13, 2015 11:35 PM
UltRoadWarrior9
Transmissions and Drivetrain
3
Sep 2, 2015 08:24 PM