Installing power plate for cutout, where to get power?
Thread Starter
Joined: Jul 2003
Posts: 2,017
Likes: 13
From: Troup, Texas
Car: 1989 Camaro IROC-Z
Engine: ZZZ# 0607 of 1200 produced
Transmission: Pro-Built 700R4/Vig.2400
Axle/Gears: 3.27 BW 9 Bolt PBR Disc
Installing power plate for cutout, where to get power?
Well guys, just curious where I could pull some good juice to operate my Q-tec electric plate. Any ideas? People who have done this where did you install it all.... thanks
Will
Will
Supreme Member
iTrader: (1)
Joined: Mar 2001
Posts: 4,226
Likes: 6
From: Chesterfield, Indiana
Car: 1991 Z28 Camaro
Engine: 5.7
Transmission: Jasper 700R4 Stage II
Axle/Gears: 3.23 For Now
I got my direct power from a fuse from underneath my dashboard...I think in the guage fuse...so when I turn my key on....is the time I can use the cutout....easy install..
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
evilstuie
Tech / General Engine
22
Jan 9, 2020 08:29 PM