where to place cutout valve?
Thread Starter
Supreme Member
iTrader: (2)
Joined: Sep 2003
Posts: 10,494
Likes: 3
From: Woodland, CA
Car: '02 Z06
Engine: L33 5.7
Transmission: T56
Axle/Gears: Stock IRS
where to place cutout valve?
ok i got this cutout valve in my hand. i want it welded before the cat.
problem is, the whole y pipe before the cat bends, so how have you people conqured this problem?
problem is, the whole y pipe before the cat bends, so how have you people conqured this problem?
Joined: Mar 2000
Posts: 43,187
Likes: 45
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
What kind do you have?
The "smartest" way, in my mind, is to make the cut-out the bend, so when the cut-out is open it's a straight shot out the opening.
One guy (forget who it was) posted a picture of one where they basically welded a cut-out cap flange on the bend so that when uncapped, it did what I described above.
The "smartest" way, in my mind, is to make the cut-out the bend, so when the cut-out is open it's a straight shot out the opening.
One guy (forget who it was) posted a picture of one where they basically welded a cut-out cap flange on the bend so that when uncapped, it did what I described above.
Thread Starter
Supreme Member
iTrader: (2)
Joined: Sep 2003
Posts: 10,494
Likes: 3
From: Woodland, CA
Car: '02 Z06
Engine: L33 5.7
Transmission: T56
Axle/Gears: Stock IRS
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
Dec 10, 2019 07:07 PM
