my mccord cutout plate isnt working
Thread Starter
Supreme Member
iTrader: (2)
Joined: Sep 2003
Posts: 10,494
Likes: 3
From: Woodland, CA
Car: '02 Z06
Engine: L33 5.7
Transmission: T56
Axle/Gears: Stock IRS
my mccord cutout plate isnt working
well i finally got around to bolting it up for the first time, the LED light comes on so I am getting power, but i push the button and nothing happens.
how can i by pass the button to make the valve work?
which positives and negative wires am i gonna touch together?
i wanna see if its maybe just the switch?
how can i by pass the button to make the valve work?
which positives and negative wires am i gonna touch together?
i wanna see if its maybe just the switch?
Thread Starter
Supreme Member
iTrader: (2)
Joined: Sep 2003
Posts: 10,494
Likes: 3
From: Woodland, CA
Car: '02 Z06
Engine: L33 5.7
Transmission: T56
Axle/Gears: Stock IRS
ok i dug up my voltmeter and discovered at the solenoid itself, i am getting power from both wires, the red and green one.
so if the solenoid is not turning the valve, but it is getting power, then it must be dead right?
so if the solenoid is not turning the valve, but it is getting power, then it must be dead right?
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
sailtexas186548
Engine/Drivetrain/Suspension Parts for Sale
8
Jan 19, 2016 12:21 PM
mhatfield 14
Tech / General Engine
5
Oct 24, 2015 07:48 AM
