Headers For Vortec Engine Swap
Thread Starter
Member
Joined: Sep 2001
Posts: 165
Likes: 0
From: Staten Island NY USA
Car: Black on Black 1989 GTA
Engine: 5.7L Vortec TPi
Transmission: 6 Speed T56
Axle/Gears: 3:73
Headers For Vortec Engine Swap
I am currently swapping a GMPP Vortec 5.7 in my 89 GTA. I am looking for a set of headers that would bolt up to the stock Y pipe and fit the vortec heads. Also, I do not need the Emision out puts on the headers, only a bung hole for an O2 sensor. Any info greatly appreciated.
Senior Member
iTrader: (1)
Joined: Jan 2004
Posts: 936
Likes: 0
From: UofA(Tucson), AZ
Car: 92 Precision Red Firebird
Engine: v6->357 vortec xe262h rpm intake
Transmission: t5-> t56
Axle/Gears: 10bolt 3.42s
could get some Hooker 2055s...thats what i have and they had the AIR and o2 bung. but thats cut and plugged on mine
Member
iTrader: (1)
Joined: Feb 2005
Posts: 471
Likes: 0
From: Frankfort, KY
Car: 81 Corvette
Engine: 355, ported vortec heads
Transmission: 700r4
For any aftermarket headers to work with the stock y-pipe you would have to get reducers and modify the stock y-pipe. Then you may also run into the issue that most reducers are a flange type. The hookers, headmans, and edelbrocks are a ball and socket style.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Mar 5, 2017 06:37 PM
Fast355
DFI and ECM
14
Dec 2, 2016 06:33 PM
