In a quest to keep precious ground clearence, im going to attempt to ovalize some pipe, i could buy it from DR.Gas but i figure its worth a try, so, my thought was to fill the pipe with a 2x4 ripped down to fit inside the pipe tight against the sides at 1.25" height and rolling it with my truck or a roller from work in hope to have a nice ovalized pipe that is only 1.25" tall and as wide as what is left over from a 2.5" pipe. The only object is to get the pipe so it doesnt pinch on the ends. Im all ears for suggestions! Thanks

 

u could put it in a vice and just crush it as far u want, might take a little time though. just my

 

or you could call boyce industries and buy the pipe as they are much cheaper than dr gas and spintech.

 

I never heard of them Thanks, ill do some research

 

I have done it in the past with the press brake at work and the tube filled full of sand. It came out very nice. The other thing I have done was to cut apart a u-bend in the middle and add in a filler peice. That worked out really well for a job that I did.