Cutting Header Flange
Thread Starter
Supreme Member
iTrader: (2)
Joined: Aug 2007
Posts: 2,529
Likes: 1
From: Fairhope, AL
Car: 89RS(other cars & pics in vBgarage)
Engine: LO3, 305 TBI Mildly Modified
Transmission: BakerBuilt 700R4 w/B&M Megashifter
Axle/Gears: 3.23 Auburn Pro Series LSD
Cutting Header Flange
has anyone cut there header flange like shown in the attached pic.
i have heard of people doing this for what i think was to stop the flage from warping or something
i know its prob been mentioned on here before but im looking for why its done and if it should be done
i have heard of people doing this for what i think was to stop the flage from warping or something
i know its prob been mentioned on here before but im looking for why its done and if it should be done
Junior Member
Joined: Sep 2008
Posts: 95
Likes: 0
From: Jackson, MI
Car: 1991 Pontiac Firebird
Engine: 3.1L V6
Transmission: 700R4
Axle/Gears: 3.23
Re: Cutting Header Flange
People do that to get a warped flange to seal properly. Personally, I would get warped flanges machined flat instead of cutting the flange.
Thread Starter
Supreme Member
iTrader: (2)
Joined: Aug 2007
Posts: 2,529
Likes: 1
From: Fairhope, AL
Car: 89RS(other cars & pics in vBgarage)
Engine: LO3, 305 TBI Mildly Modified
Transmission: BakerBuilt 700R4 w/B&M Megashifter
Axle/Gears: 3.23 Auburn Pro Series LSD
Re: Cutting Header Flange
o i c
Thread
Thread Starter
Forum
Replies
Last Post
