Need some header install tips.
Thread Starter
Joined: Jun 2007
Posts: 135
Likes: 20
From: Albuquerque NM
Car: 1985 IROC
Engine: 350HO
Transmission: T56
Axle/Gears: 10 bolt 3.23 limited slip
Need some header install tips.
Hello,
I just purchased some Headman 68471's headers (shorty's with air tubes) from a member here on the boards. I need to keep the air set up to pass emissions. There going into my 86 IROC. I wanted to know if anyone here has installed these and how you did it. I've done some searching and there isn't a whole lot of info about the installation process.
Also should I buy a y-pipe to fit or have my buddy fab one? He is an expert w/exhaust, so I'm not worried of some POS hacking up my car. Which way would be cheaper/better?
Here's some pertinent info.
- 86 IROC Z28
- 700R4
- 355 cubes
- TPI
- Stock A/C system (not working)
- Single 3" mandrel bent cat back exhaust
- V belts
Thx,
Ted
I just purchased some Headman 68471's headers (shorty's with air tubes) from a member here on the boards. I need to keep the air set up to pass emissions. There going into my 86 IROC. I wanted to know if anyone here has installed these and how you did it. I've done some searching and there isn't a whole lot of info about the installation process.
Also should I buy a y-pipe to fit or have my buddy fab one? He is an expert w/exhaust, so I'm not worried of some POS hacking up my car. Which way would be cheaper/better?
Here's some pertinent info.
- 86 IROC Z28
- 700R4
- 355 cubes
- TPI
- Stock A/C system (not working)
- Single 3" mandrel bent cat back exhaust
- V belts
Thx,
Ted
Last edited by Bustionironi; Jun 12, 2010 at 04:09 PM.
Thread
Thread Starter
Forum
Replies
Last Post
