do you guys think i can make these work?
Thread Starter
Junior Member
Joined: Sep 2010
Posts: 64
Likes: 0
From: Maili HI
Car: 1989 RS,1991 Z28
Engine: TargetMaster 350, L98 350
Transmission: 700R4
Axle/Gears: 10 bolt posi 2.73s, and 3.23s
do you guys think i can make these work?
i found these headers and really need a set do to not wanting to use my manifolds. by looking at them and a set from hawks they are close but obviously not the same. does anyone think i can make these work? i dont have a problem modifying them if i have to but just curious. im talking about the set on the right. any help would be appreciated...
http://madison.craigslist.org/pts/2147568402.html
http://madison.craigslist.org/pts/2147568402.html
Joined: Aug 2006
Posts: 12,807
Likes: 108
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: do you guys think i can make these work?
very unlikely, even the 3rd gen specific long tube headers are areally tight fit, and those are totally different. Pass on them, you need 3rd gen specific fit headers.
Thread
Thread Starter
Forum
Replies
Last Post