Re Use of Ripped / Torn Header Gasket?
Thread Starter
Member
iTrader: (9)
Joined: Aug 2006
Posts: 216
Likes: 0
From: Los Angeles
Car: 88 Iroc-Z
Engine: 355 AFR-195 FIRST Fuel Inj.
Transmission: T56
Axle/Gears: ??
Re Use of Ripped / Torn Header Gasket?
I have a set of Earls header gaskets, EAR-29DD3BERL. They are going between the block (obviously) and set of Dyno Don's headers. Unfortunately the insert fell out, and while I was putting it back, it ripped. See the pictures below. Would you guys recommend I get a new set, or can I re-use these?
Joined: Mar 2000
Posts: 5,703
Likes: 132
From: Orange, CA
Car: '90 Trans Am-12.45@110.71
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73
Re: Re Use of Ripped / Torn Header Gasket?
Not a probem, you can use them, I have many times that way.
PS the intake is ready.
Don>>>
PS the intake is ready.
Don>>>
Thread Starter
Member
iTrader: (9)
Joined: Aug 2006
Posts: 216
Likes: 0
From: Los Angeles
Car: 88 Iroc-Z
Engine: 355 AFR-195 FIRST Fuel Inj.
Transmission: T56
Axle/Gears: ??
Re: Re Use of Ripped / Torn Header Gasket?
Thanks Don. I'll swing by this Saturday to pick up the intake.
Thread
Thread Starter
Forum
Replies
Last Post
AmpleUnicorn88
Interior Parts Wanted
16
Nov 29, 2015 05:45 PM
