Header's accessories needed
Thread Starter
Senior Member
iTrader: (9)
Joined: Jun 2002
Posts: 742
Likes: 0
From: La Mirada, California
Car: 1991 Camaro RS
Engine: L98 350 TPI
Transmission: 700R4
Axle/Gears: ZT LSD with 3.42 - LS1 brakes
Header's accessories needed
Hey all,
I'm picking up a set of used edelbrock TES shorties, and was wondering if I will need anything to go along with it. Having never done headers on any vehicle, this will be my first time, and want to run into as few issues as possible...
I know that I'm gonna need loctite for sure, and header gaskets, any PN recommendations for the gasket? (1-5/8", stock L98 heads)
What about bolts or other hardware?
Thanks!
-Tim-
I'm picking up a set of used edelbrock TES shorties, and was wondering if I will need anything to go along with it. Having never done headers on any vehicle, this will be my first time, and want to run into as few issues as possible...
I know that I'm gonna need loctite for sure, and header gaskets, any PN recommendations for the gasket? (1-5/8", stock L98 heads)
What about bolts or other hardware?
Thanks!
-Tim-
Joined: Mar 2000
Posts: 5,703
Likes: 132
From: Orange, CA
Car: '90 Trans Am-12.45@110.71
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73
Re: Header's accessories needed
Tim:
If you want to save yourself some grief, come by and I will explain it all to you.
There are some real issues to deal with.
If you want to save yourself some grief, come by and I will explain it all to you.
There are some real issues to deal with.
Thread
Thread Starter
Forum
Replies
Last Post