air induction
Thread Starter
Junior Member
Joined: Feb 2009
Posts: 6
Likes: 0
air induction
I swapped a 1979 350 into my 83 z28. Had the LU5 option with functioning air flaps on hood. How can i hook up the the solenoid on the hood to open flaps again under throttle? ECM is gone.
Last edited by jeff loomis; Mar 17, 2009 at 09:51 AM.
Senior Member
Joined: Feb 2008
Posts: 441
Likes: 0
From: Sanford, FL
Car: 92 RS Camaro
Engine: 305 TBI
Transmission: T5
Axle/Gears: 3.08
Re: air induction
umm maybe a pedal switch
what would Mac Guyver do?
I know he would buy a cheap shift lite and take it apart and disconnect the lite and run the power wire to a 12v relay that gets power when the car is on, from the relay he would hook up the solenoid. From this he could set a certain rpm and at that rpm it would send a continuous signal to the relay that would open the flaps when needed.
I would just leave them open all the time but im not that creative.
what would Mac Guyver do?
I know he would buy a cheap shift lite and take it apart and disconnect the lite and run the power wire to a 12v relay that gets power when the car is on, from the relay he would hook up the solenoid. From this he could set a certain rpm and at that rpm it would send a continuous signal to the relay that would open the flaps when needed.
I would just leave them open all the time but im not that creative.
Thread
Thread Starter
Forum
Replies
Last Post
